Assembly (Sega Multi Mega)

Place the top lid upside down, then re-insert the top PCB into the case, putting the laser in first, then the side with the green Phones connector in first, until it drops into position.

Install the metal shield with the power button attached, making sure to slide the power button in first.

Re-install the 7 gold Philips screws.

Place the motherboard back into position with the controller and power ports going in first, and then the connector pins on the rear right side (when upside down) and push down until they insert into the slot.

Screw in the 2 gold Philips screws to the back board.

Stick the copper shield back down.

Place the rear cover on and install the 4 long Philips screws.

Reinstall the small Philips screws on each side of the console (right, left and back).