Super GamePad+ Guide

the supergamepad+ features both wireless and wired features configuration configuration includes setting your rgb colors, setting custom remap profiles, and more home/capture macros (switch mode) to go home , press select+r trigger to perform a capture , press select+l trigger wired mode simply connect your supergamepad+ via a usb c cable to enable wired modes holding down one of the alternate mode buttons while plugging in will boot into the desired mode as you connect to pc you should get a prompt to open the web interface you can use to configure the options, leds and more wireless mode to power on the controller in wireless mode, hold the select button for a few seconds until the controller turns on holding down one of the alternate mode buttons while powering on the controller will boot into the desired mode pairing to switch to pair your supergamepad+ to nintendo switch consoles, go to find controllers > change grip/order from the switch home screen menu hold start while powering on the controller to enable pairing mode the controller will connect the connection is remembered the next time you power on your controller pairing to pc hold x while turning the controller on the controller will flash green to indicate wireless xinput mode in windows, go to your bluetooth settings > add device > bluetooth select your gamepad from the list due to issues with windows bluetooth stack, this may take 1 2 tries if it doesn’t work the first time, remove the device, reboot, and try again modes explainer hold the appropriate button while powering on the controller (wireless mode) or while plugging the controller in via usb button led color mode bt usb description a white switch/config ✔️ ✔️ usb mode for nintendo switch or the config app x green xinput ❌ ✔️ usb mode for steam or games supporting xinput at 1000hz y cyan slippi ❌ ✔️ usb mode for slippi on pc/mac/linux/android b blue sinput ✔️ ✔️ usb mode for pc/steam to support 1000hz input dpad left red nes/snes ❌ ✔️ connect to an nes/snes console using a retro c cable dpad down yellow n64 ❌ ✔️ connect to an n64 console using a retro c cable dpad right purple gamecube ❌ ✔️ connect to a gamecube/wii console using a retro c cable switch mode locate and enter system settings scroll down until you see controllers and sensors press a , then locate and enable pro controller wired communication you will see a prompt about nfc functionality, press ok you now have pro controller wired communications enabled