CleanPower USB-C (Mega Drive)

the mega drive cleanpower is a usb c power mod for the mega drive console to allow you to power it from any usb c or usb a to c cable/charger you can even power your mega drive from your phone by a usb c to c cable! install is pretty simple; screw the pcb to the provided bracket with the 2 screws o pen the console up and locate the two voltage regulators the large 3 pin devices below the dc power input then bridge the outside two pins using the wire provided from the other side do this to both regulators locate the d1 and d3 diodes near the power switch flip the board over and bridge the pins where d1 and d3 would be you only need to bridge one of them as they are joined these were for reverse polarity protection of the old dc jack which is impossible with usb, and this drops the 5v input to 4v so needs to be bridged next, remove the old dc port, disconnecting the white and red wire from the dc jack place the cleanpower in place as shown and then solder the white wire to ground, and the red wire to vcc once you place the top lid back on it secures and locks the cleanpower in place you can now use any usb c to c or usb a to c cable, and any charger at all, and it will work to power your console any current and voltage is ok, as the usb c protocol negotiates voltages so you will only ever send 5v into the console, and the current will only pull what it needs